#Rel. 3 Crash on Exit
Life was so good, I had such high hopes……….
I just bought rel. 3 3ds on Monday and installed it on my 486/66 VLB w/ 32 Mb
RAM w/ AMI bios dated 6/10/93 and a 2 Mb Diamond Viper VLB VGA ver. 2.02 and a
VLB IDE controller, and typical KB, floppies, HD.
………….the trick to the following is it only happens on exit of the
program…………
I am receiving the dreaded "QEMM 7.01 exception 13 error"….. and/or a
"PharLap error 10051:ran out of machine struct" (?????)
The error depends on the exact config that I try. The one common fact is that
I cannot exit without the crash.
I have tried all of the different Diamond Vibrant drivers and the VESA drivers
as well as all of the cfig386 settings I know how to set and I get the same
crash situation as I exit.
3ds rel. 2 ran fine with my SONY EVO 9650 and a Diaquest DQ-232 controller, all
which have performed flawlessly for the last year.
The interesting thing is I still can draw and save and render while in the
program, it just dies as I exit (!). Even though I have wasted a week on 3dsR3
I still "like" this program.
JD