Connect Problem
Hello. I'm having a new problem when I connect with Compuserve.
I have the SupraFAX Modem 9600bps. I have been linking to CIS with LAPM and
from 300 to 9600 bps without any problems. Even flow control worked.
I haven't changed my software and as far as I can see I still use the
factory defaults, so I don't know where my problem began.
The software loads normally. The program functions right up until I connect.
I get the CIS prompt and the host doesn't seem to receive any future input. I
also tried the demo version of AutoPilot, but when I get to the CIS prompt,
again CIS doesn't seem to receive my transmission strings.
If I do a "at\n1" however, I can connect to CIS but without data
compression, or error checking.
Does anyone have any idea's what may have caused this? Thank you in advance.
Regards, Henry