STARTUP
Joan,
From the dos window, type "LOADWB" and press return. This will load
the Workbench graphical interface. After doing this, typing "ENDCLI" and
pressing return will cause the original DOS window to close, leaving the
Workbench interface.
Normally, these commands are part of the standard "startup-sequence"
command file, which is located in the "s" directory of the disk from which
you are booting. I would guess that somehow you either changed or deleted
this file, which is why you are not getting the desired results.
You may want to consult the corresponding startup file on your original
workbench disk and (most likely) copy it to your normal boot disk.
Hope this helps….
– BobR
(Motorola Inside!)