CompuServe Messages

Norman, The Mountlist stuff is for old (OS versions. All that stuff is now saved in the Rigid Disk Block in the harddrive itself. The Harddrive manual comes with the original manual set of the 3000 and 4000. What parameters are you entering in the HDToolBox partitioning requester (that is, what are you changing?) Does the HDToolBox reckognize your Bernoulie as such? It should have an entry in the main requester. Also, although I don't think the low level format is doing anything, you should never do it except as a last resort when you have a disk that's really in bad shape. I think most drives ignore it. If you did do a successful low level format (they take a while), you would have to partition your drive again, as the RDB would be cleared. This works if you are using a C= controller, i.e. a 3000 or 4000 internal SCSI or IDE. If you have a third-party controller you may need to use their own disk partitioning software. Can you give some more info on your hardware setup? DJ On AP from Queens, the thrill and excitement of the Big Apple Where a little paranoia is always a healthy attitude …