CompuServe Messages

Mark, I tend to have bad feelings on this bug that you are claiming here because the DXF is Autodesk's utility. It would seem, on the surface, that the problem lies with the program on the RS/6000 not writing a compatable file for the DXF interface. But I have a suggestion. Did you try to import this DXF into a *NIX version of AutoCAD ???? This should clear up any problems with the <LF> and the lower case in the DXF initially, and if it doesn't, it would again point to the program on the RS/6000………(but you didn't want to hear that, did you ???) The next solution would be to write a little program to convert the <LF> to <CR><LF> and to convert the lower case to upper case to run on the DXF before importing it to DOS ACAD. If this clears up the problems, you got the answer, but I really have a feeling that this won't do it.