#Bridgeboard &*%#!
HELP!!!!
I just picked my 2000 up and was ready to hurl it across the room,
when I realized how much money I was holding, and put it gently back
down. Now that I've calmed down, here is the problem:
I just installed a AT Bridgeboard, and created a psuedo hard drive,
which works fine. I then went to load some software into the PC side
through the 5 1/4 drive (1.2m) and I got a General Failure error reading
drive A:
I checked my prefs, and the drive is set up as a 1.2 and if I set it
up as a 360, it doesn't work, so it must be a 1.2 meg.
The drive reads the MS-Dos and Janus disks just fine, but I get the
same error if I try to read any other disks.
I tried some that are 1.2 meg and some that I know are 360, and it
will not read anything other than the disks that come with the bridge-
board.
What is going on here??? Anybody?
…Cruising on AutoPilot from Northern Indiana…
Branden Beachy
72557,107