#DrawPlus Problems
20-Dec-87 01:05:12
Sb: #DrawPlus Problems
Fm: BILL LEACH 71330,2621
To: Aegis Development 76067,2500
This message turned up in search, but its forum couldn’t be identified from the original transcript, so it may not be linked into its thread.
I have DrawPlus and have not fooled around much with it until today
(just have not had time). Seems that I can not retrieve any parts. The
load parts requester comes up ok. Selecting one or more parts files works.
Hitting f10 yields a parts inventory listing the parts that were loaded or
created on the current drawing. Selecting one of the parts is accepted ok
but when you try to paste the part to the drawing all you get is 'part not
found.'