A3000 Help, Please
16-Dec-92 09:02:06
Sb: #81490-A3000 Help, Please
Fm: BILL LEACH 71330,2621
To: Steven D. Kapplin 70055,1021
Steven;
I guess I'm comming into the middle of this so forgive me for the
obvious.
Have you tried setting the Konica to an address higher than all other
drives in the system (ie: 6, and move drive 6 down), set the last drive
bit in the rdb for the drive just below the Konica? Then try cold booting
with and without a disk in the Konica (and maybe off as well).
You could also try setting for 128 mSec under those conditions to see if
the system will boot. SCSI mounter could then be used to make the
recognized.
As an aside, if you set LUN's on, the delay time can increase
significantly (a factor of 8).
-bill