#Sealth 32 & NT 3.5
26-Nov-94 18:27:30
Sb: #Sealth 32 & NT 3.5
Fm: Terry Griffin 74131,3227
To: Jaime Pirnie [Diamond] 75300,3673
I have recently purchased a Diamond Stealth 32 to replace an Orchid Prodesigner
II. Part of the rational for the Stealth 32 is that it is compatable with the
ET4000 chipset used on the PDII. I was very disappointed when I installed the
new version of NT 3.5 Workstation. If I select teh Diamond Stealth 32 setting
from the Display manager, it appears to only drive the card in the interlaced
mode at 1024×768 and at 60hz at 800×600, both resulting in very annoying
flicker. I tried the built-in driver with both a Nanao 9070U and a Mag MX17
monitor. Same results on both. I have installed the NT 3.1 drivers that came
with the card and they appear to work correctly, except that the new Control
Panel Display utility complains about them bein "Down-level" drivers.
Is there an updated driver for NT 3.5 available?
Thanks,
Terry Griffin