acad2.6/compaq20mhz
06-Apr-88 19:03:51
Sb: #21576-acad2.6/compaq20mhz
Fm: renwick preston 73117,3301
To: Steve McCall [ADESK] 73417,2234
This message turned up in search, but its forum couldn’t be identified from the original transcript, so it may not be linked into its thread.
Steve, thanks for replying so quickly. I will try your solution of turning
off memcache. I can't quit using 2.6 yet for a couple of reasons. One, I am
in the middle of a big project in which a large number of drawings have
already been created using 2.6 . Also, we have already upgraded to Release
9 and have discovered that Sigma still does not have a driver for the
Laser-view monitor that we use. We could use the Laserview but the pull
down menus do not work. By the way, the name of our company is S $ B
Engineers, Inc. We have several (all registered) copies of Acad, one of
which is serial # 01-846869 in case you are interested. As a side note, the
Autocad Dept. leader and I were reading some of the messages in this forum
and we came across the one about people buying cheap $1850 copies of Acad
and expecting support. Well, our experience has been that even though we
fork over somewhere in the neighborhood of $2800 for our Acad we still do
not get good support. The vendors around here do not know nearly as much
about Acad as we do. Furthermore, hardware support is almost not existent
as well. So, to us, it does not matter what we pay, we still do not get
good support. Again, thanks for the quick reply. Ren Preston