CompuServe Messages

Don, This is the assign list from the HD startup-sequence: (Without a disk in df0: or df2:) Volumes: PCvd0 [Mounted] <—- (DH1:) Amiga [Mounted] <—- (DH0:) Directories: S Amiga:s L Amiga:l C Amiga:c FONTS Amiga:fonts DEVS Amiga:devs LIBS Amiga:libs SYS Amiga: Devices: DF2 DF0 PRT PAR SER RAW CON RAM DH0 DH1 One more assumption. I AM jlinking after the Bridge side boots. I have a PC boot disk. It has WB 1.3 files in addition to the Bridge files. I execute binddrivers from there (since I can't do it from the hard disk). It works fine. I then reassign the above devices and directories to dh0:. I open the pc drawer (on dh0:), run pcdisk, then pcmono. The pc screen comes up. No problem. I can jlink to ram: or floppy, but not to the hard disk. If I don't reassign; leave df0: as sys:, same result. Everything boots ok, (Workbench and PC) but can't jlink to hard disk. Below is the assign list of the pcboot disk with the assign command just before binddrivers. Volumes: PCvd0 [Mounted] Amiga [Mounted] 1.3PCboot [Mounted] Directories: S 1.3PCboot:s L 1.3PCboot:l C 1.3PCboot:c FONTS 1.3PCboot:fonts DEVS 1.3PCboot:devs LIBS 1.3PCboot:libs SYS 1.3PCboot: Devices: DF2 PRT PAR SER RAW CON RAM DF0 DH0 DH1 That shouldn't happen. Right? Dennis