CompuServe Messages

Hi Phil I am not sure what your problem is but, you might try what I did. I have the pals grounded together with one piece of wire that then runs down to the large ground plane beside the expansion connector beside the 68000 socket. I also have this wire run over to the ground hole beside the ANAKIN marking on the Lucas board ( as documented in the stuff from Brad Fowles). I have a jumper wire from the left front of Frances board down to the motherboard ground plane as well. I have done the Pixar Hack to the Lucas board to fix a intermittant startup problem. and I have done the CAS hack to the Frances board. I am using a modeload parameter of 36C4E4 because I am running at 14.1 MHZ because I was using a 12 mhz 68881 and it would get flakey at anything higher. I ran with two meg of 32 bit ram with out a hitch for about 8 months but I recently added 2 more meg and now I am having trouble with Digipaint bombing most of the time. Every other program seems to be ok . I have run all sorts of stuff that are quite Ram/Cpu intensive (TurboSilver, Sculpt 4D etc) and they work fine just Digipaint3 dies ????. Regards John Lemoine 75320,143