#Show 'Em??
4 messages in this thread
Dear Yost group,
A simple suggestion to help us help you develop applications
for 3ds in Landscape Architecture.
Problem: How to get aniplay or ani to display through our
targa 16 + board and fill the computer screen fully?
The Targa plus drv give a good image, it goes to my home
vcr but its sooooo damn small! Not a way to convince people
the merit of your products.
Frustrated
Holding my breath
Curt Westergard 410-740-9349
There's no ani pro display driver for the old Targa16 board, but there is an
excellent driver for the new Targa+.
– G
Curt,
Just use the Targa+ driver for Animator Pro (from Truevision – on the
Targa+ setup disks). You need to set the Targa+ to display 512x486x16-bit
overscan mode. You will need to create any animations in the same resolution.
You can do this by running Animator Pro directly on the Targa+, or rendering
from 3D Studio @ 512×486 with an aspect ratio of approximately 1.23
Kevin Krell – Computer Support Associates
I hadn't realized that it was a problem. (I'll confess that I haven't used the
targa to output to a VCR.) But have you configured the Targa correctly?
Our setup includes the following in the autoexec.bat:
set targa=247 (see config: 0xD000 + 0x220)
set targaset=T16X0Y0I0BGC51H51S53P200 (T16=Targa type
X and Y screen
position offsets
Interlaced
default
Genlock On to
external source
Contrast
control default
Hue default
Saturation (58
is the default)
Scanlines in
NTSC field)
c:\tplus\tmode 11 (NTSC, 512x486x32)
and in the config.sys:
device=c:\tplus\targap.sys md i220 (memory segment 0xD000
base IO address
0x220)
Does any of this help?
Best,
Nik