#3D-STUDIO
2 messages in this thread
Hello,
I have another question. I need to know how to print a 3d-studio
drawing as a standard drawing, not rendered or anything. Just a 3d drawing
with lines. Can anyone tell me how to accomplish this feat?
Thank you, Chris
One way might be to use the screen capture utility (see doc below for info in
how to use it). The only thing – you'd have to make use the Full Screen
Toggle, and after your image is created, crop off the top and side and bottom
menus.
File Info for R3HIDN.TXT
Section: Autodesk 3D Studio Contributor: 76702,413 Size: 8971
Submitted: 12/15/93 Type: Text Accesses: 1116
Title: Undocumented 3DS.SET parameters in 3DSr3.
Keys: UNDOCUMENTED 3DS.SET PARAMATERS USEFUL IN 3D STUDIO RELEASE THREE
This document describes 10 undocumented features in 3DSr3 that can be
accessed via new commands in the 3DS.SET configuration file. Note that these
commands are untested, and I make no guarantee that using them will not
cause anomalous behaviour. However, 4-5 of them can be quite useful under
certain circumstances (described in the text).
– Gary Yost