[A Hello, I hope someone might be able to answer this question. I have
installed Autodesk Animator Pro onto my 386/25 where it works fine with one
exception. I am using an USVideo VGA/NTSC card driving a standard VGA
(640X480). When I try
[ATo retrieve any thing larger than 320X300, it only shows a portion of the
Gif or image. It is clear, but partial (about 1/6th). I am making the
settings as correctly as I know and still experiancing these problems. Anny
suggestions?
Thanks, Rob Bradish 75556,570
Does that 1/6th image fill your entire screen? If so, you are not using
the 640×480 driver and are still in 320×200 mode. You need to a) load the
VESA driver for that card – it may come with the card or look in your
\ani\vesa for the correct driver. Read docs if you don't know how!
b) Go to Screen Size in the far right menu in AAPRO and pick 640×480 vesa
driver.
If you have taken the above two steps, I assume the picture only fills up a
part of the screen. In that case, c) go to the flics menu (2nd from left)
and pick Reset. Then set the Flic size to 640×480.
Anil