Resolution Q
5 messages in this thread
I have what is most likely a dumb question, but I can't figure it out…
Sometimes when I load an image from ADPro (2.1.3) into DPaint, DPaint reads
it as a different resolution than ADPro. For instance, cropping an image
to 704×480, saving it and then loading it into DPaint will give me 736X480
in DPaint. If I load it back into ADPro, it says it is 704. Any ideas as
to what I am doing wrong?? -JG
John, I've had the same problem too. I'm using DPaint IV. Is that what
you're using.
Kevin Ushko
Edmonton, Alberta
Yes…I wonder if it's a Dpaint IV prob???
John,
I've done a bit testing, and DPIV only seems to know two sizes of
overscan: STD (352 x 480, 352 x 240, 704 x 480 , 704 x 240) and MAX (368 x
482, 368 x 241, 704 x 482, 704 x 241).
Any overscan picture loaded in will use one of the page sizes listed.
So if you want to use DPIV you will have to render to these sizes, or
scale the images before loading into DP.
Kevin Ushko
Edmonton, Alberta
Kevin, That makes sense (although I think you mean 736×482 for max…) but
I've had images go both ways…e.g. I've taken a 704 wide image from Dpaint
and load it into ADPro and ADPro states that its 640 wide or vice versa. JG