#Start-up problems.
4 messages in this thread
#Start-up problems. — declared parent_msg_num=(none), resolved parent_id points to #(none)
Every time NT starts up, I get the standard "At least one serice or
driver failed…" It's caused by the following "errors."
1) "While validating that COM2 was really a serial port, a fifo was
detected. That fifo will be used."
2) "The borwser has forced an election on network \Device\NBF_Elnk301
because a master browser was stopped."
3) "The browser has forced an election on network
\Device\Streams\NWNBLINK because a master browser was stopped."
The first one is correct in that the computer does have a 16550 UART,
but I've been unable to set that as a permanent setting.
As far as the other 2 go, the WNTRK basically says that the "election"
is no big deal, and that no changes are necessary. That's all fine and dandy,
but the "light" next to the error(s) are red and the "At least one…" comes up
every time.
What's the next move?
jason
There is 1 Reply.
Read action !
#180347-#Start-up problems. — declared parent_msg_num=180347, resolved parent_id points to #180347
<<What's the next move?>>
these are popup messages or messages in event viewer.
There is 1 Reply.
Read action !
#180380-#Start-up problems. — declared parent_msg_num=180380, resolved parent_id points to #180380
Yes, they are. I'd like to avoid these from popping up the "At least
one service…" message. I know they're not really errors, but NT seems to be
insistent that they are…
jason
There is 1 Reply.
Read action !
#180440-Start-up problems. — declared parent_msg_num=180440, resolved parent_id points to #180440
all the pop ups I get are errors, maybe transient but errors. What all have
you set up for automatic services?
Read action !