I have been living with a minor annoyance for quite some time and am finally
getting around to asking what the heck is going on. On some models in the 3d
Editor and Keyframer only about a quarter of the edges of my meshes are showing
up on screen. I have "edges only" set up as my display option. This is not a
result of speed, since this is turned off. Has anyone else had this peculiar
problem?
It sounds like you hit the "V" key by mistake, which turns on Fastview
in the current viewport (which will display nth edges). You can see
if it's turned on if Fastview is asterisk'd in the View dropdown.
Tyler,
If you have 3DS set up to display edges only, it will only show those edges
that are facing you. If you make 'SEE THRU' active also, you should be able to
see all edges. Hope this helps…
Bob W.