#WACOM
7 messages in this thread
Hi Gary,
Sorry to bug you, but a couple weeks ago (re:MeshPaint) you told me that I
could configure both mouse & Wacom tablet, and switch back and forth within
3DS. I tried this last week, and I could switch from mouse to tablet *once*,
…after that, the s/w reports "can't find that driver" when trying to switch
back to the tablet. Also, the tablet operation was very quirky using either
normal or pressure stylus.
Any ideas ? Maybe there's a newer/better driver ? I set this up with the tablet
as default in 3DS.set, configured the 3dadi.cfg for the tablet/stylus using
Polled/Absolute. It's interesting, because even though it says the driver gets
"lost", the program's able to beep the tablet on exiting the program.
Thanks,
BILL
hmmm… I don't remember that message. Are you sure _I_ answered it? (heck,
I've been so busy that I suppose I could've said anything! 🙂
I'm completely unfamiliar with the wacom drivers, and you'll have to contact
one of the Adesk guys for help on this.
– G
Gary,
<< hmmm… I don't remember that message. Are you sure _I_ answered it? (heck,
I've been so busy that I suppose I could've said anything! 🙂 >>
Yeah, but it actually was about 6 weeks ago (time flies)<g>. I'll check around.
Thanks,
BILL
Bill,
I just installed a WACOM in an install with 3DS for a customer. There is a
WMOUSE program that you can put in your autoexec.bat file that will enable the
WACOM to emulate a MS Mouse when in DOS app's. Just setup your 3DS for mouse
and it should work just fine.
Ang, President Dynamic Technologies, Inc. An Autodesk Systems Center for
Multimedia in MD
<< There is a WMOUSE program that you can put in your autoexec.bat file that
will enable the WACOM to emulate a MS Mouse when in DOS app's. >>
Yes, I used it a long time ago. So, are you saying that:
1) You can use an *actual* mouse and the tablet w/ WMOUSE in the same session ?
2) And, neither driver will get blown out as you switch back & forth ?
Thanks Angelo,
BILL
There's a better way to use your Wacom tablet in 3DS. Wacom has this file
called UDC-config. It changes the command set of the tablet. I use this to
get the Wacom tablet to use the Suma driver built into 3DS. The file is on the
Wacom forum on AOL. I'm not sure if they have it on CIS, but you can look for
it. It works pretty good to…. you can use the tablet in absolute mode.