CompuServe Thread

#Amiga 2000

5 messages in this thread
#99465From: Pat RizzoMay 12, 1993 5:12 PM
I have had a problem with my Amiga 2000 ever since I bought it 3 years ago. It seems to "overheat" in the summer time or whenever the room is too warm. When this happens, my graphics mess up or I get a "Guru Error." Has this happened to anyone else? If so, what was the cure? Commodore says it is probably the power supply, but others have blamed the one meg. fatter Agnus.
#99555From: Don Curtis/SYSOPMay 13, 1993 2:00 AM
Pat, Generally heat related problems are chips not fully seated in their sockets…or poor solder joints. If you're familiar with electronics…you could open up the Amiga and make sure all the socketted chips are properly seated. If you're not familiar…I wouldn't attempt it, have your local dealer (if you can find one anymore) do the job for you. Don
#99732From: Andrew PorterMay 14, 1993 12:04 PM
I've had a similar problem with my 2000 although it only happens with hires and with a few programs (Prowrite,Propage/draw). I was told it may be my fast ram so I removed it, checked the connections and replace the ram board. That seemed to fix it. I was also told it was chip ram but fiddling with the ram board seemed to discount that theory. I also didn't notice any relationship between the temperature and the problem, so we may not be experiencing the same problem. By "mess up" what exactly do you see? Andrew
#99770From: Pat RizzoMay 14, 1993 4:28 PM
Andrew: Thanks for your reply. My computer only "messes up" when the room temperature nears 80 degrees or higher. I work in Deluxe Paint IV quite a bit and that seems to touch off the problem a lot sooner than other programs. I may be working on a picture (usually hires) and it will get ghost figures that cannot be removed and after awhile, the computer will either get a Guru or blank out completely. It never happens in Winter when the room temperature is cool.
#99874From: Andrew PorterMay 15, 1993 10:07 AM
Well, Pat, hmmmm… …No, I've never had that problem. With mine the menus would get messed up as if someone had scratched out menu items with a pencil and the drag bar would have artifacting. Have you looked inside to check that the fan is clear of wires and/or lint? How many internal peripherals do you have? Unfortunately I haven't any experience to help you further except say that perhaps get an air contioner for your computer room 😎 or pay to get it looked at. Andrew