#ADPro Install blues
2 messages in this thread
I just recently purchased ADPro 2.3.0…and I'm having a bit of a
problem getting it to install on my computer.
I have a 2500/30 (with C='s A2630 card w/4meg 32bit ram). I am using
Kickstart 2.04 and WB 2.1. HOWEVER, I actually have Kick 1.3 in ROM,
I am using SetCPU to load the 2.0 rom image off disk then reboot
under Kick 2.0.
Everything has always worked fine (I've had this setup since I was one
of the first people to get Kickstart/Workbench 2.04 and found out
they couldn't use the ROM cuz my 2630 ROMs needed one more revision
to accept the new Kickstart—so since I've found this solution, I've
never bothered to upgrade my 2630 ROMs).
What is happening is that when I run the Install program, I answer my
user level (tried both Inter. and Expert), then told it to Install
for Real with no logging. Once I OK that requester, it says "Working
on installation…" and never goes anywhere or does anything.
I know your Install works fine under 2.1…I also have a 3000 that
worked without a hitch under 2.1…so I'm assuming its got to be
something from my unique Kickstart situation.
Does anyone have any possible ideas as to what I might modify in the
Install-ADPro script to try to bypass any Installer-code that may be
causing the problem?
Any help would be greatly appreciated!!!