#PAR video capture
4 messages in this thread
I have both the PAR and the TBIC cards.. I have done this before, but now I am
stuck again. I followed the diagram on page 24 of the PAR manual, only
difference is I am using the "S-Video In" slot instead of the "Video In" slot.
I do not get an image on my Program Monitor from my Source VTR. I am using
Version 1.3 because I cannot get 1.5 to work on my system. I have tried
switching S-Video and Composite but I still just get this pink screen on the
Program Monitor. Anybody have an idea on configuration? Thanks.
-James Franssen
Be sure you have selected "S-Video" vs. "composite" in in the TBC IV menu of
the Par.exe and also select the EE from the main screen. This will feed the
vcr playback from your s-video TBC input jack to the PAR output, either
composite or S-video.
>> Be sure you have selected "S-Video" vs. "composite" in in the TBC IV menu
of the Par.exe and also select the EE from the main screen. This will feed
the vcr playback from your s-video TBC input jack to the PAR output, either
composite or S-video. <<
Did that 🙁 I stil get a pink screen.
-James Franssen
I hate to do this trouble shooting one message at a time but have you checked
the TBC IV as a stand alone for throughput?, the Par as a stand alone for
animation output?, If both work then maybe you should check the cable linking
the two together. You may not have it plugged in properly. Or the cable may be
defective. The pink screen is very strange. Have you called DPS tech support?
Does it work OK in composite and just not in S-Video mode? Could be defective
cables, have you swapped cables? These are some of the checks I would be doing
to isolate the problem BEFORE calling DPS.