#Mfree error
2 messages in this thread
To all,
We are an Arch/Eng firm utilizing 3DS, and have received an error msg,
which we are not familiar with.
The error occurs while moving selected vertices in the shaper. The system
appears to lock-up, however, I can use the F keys to switch modules. The
cursor disappears when the system "hangs", when it reappears, moving the mouse
will cause it to again disappear. When quitting 3DS, this error msg appears when
exiting to DOS –
Mfree error — validity check failure!
prt1 = 2e15ac. prt2 = 2e5fe8, *prt1 = 4a40, *prt2 = BFD88000
The screen then is paused, hit return and the the following is displayed
Freeing shp2d
C:>
The same error will occur repeatedly (at least 3 times) in this PRj file,
however, in other PRJ, there is no problem. No other problems have been
experienced, and no system changes in the last 8 mos. Virus scans have turned
up clean. I can provide more info if necessary, and will try the PRJ file
on another machine soon.
Any ideas? Thanks in advance.
Marty
Marty:
I've never even heard of that error message, must be pretty obscure! :^)
But I think you're right, it's a glitch in the file somewhere.
Try this: Load the project, go into each module, and save the info separately
(not as a project).
Close 3DS (to make sure you have a clean start) and load each module by itself
to see where the glitch is. If it still appears, save out that module as a DXF
and try to bring it back in (with a clean load of 3DS).
Let me know how it goes!
Greg Pyros