David,
If you've had this board for sometime, it may not be a drivers
problem. Did you go through the propoer Viper INI setup?? I'm an
amatuer at this stuff, but it sounds like that may be YOUR problem.
Brian:
The board came in a system from Micron that arrived a couple of weeks ago.
Everything works fine with 3DS 2.0 and everything else I've tried to run on
it. But when I try to configure 3DS 3.0 (with your company's inline driver)
to render at any resolution higher than 320×200 and a color depth higher
than 256 colors, I get that error message.
David