HI. Quick question. I just got the PDraw 3.0 upgrade, installed it. All
appears to be working fine, however looking through the book, it tells me
to insert or delete a point, I just have to click on the tools, and it
appears there is some blank space in the bottom of the tool area where two
tools might go. I do not yet have AREXX, but the way I read the book, it is
not required to use these two tools? Currently using A2000, 5mg RAM, 1mg
Chip and hard drive. Any help appreciated. If I do need the AREXX, I'll
order tomorrow. Thanks Bob.
Bob
By the `insert' and `delete' a point, I assume you mean the `add a control
point' and `cut a control point' tools.
ARexx certainly isn't required to use these, and they should be displayed
at the bottom of the tools.
You should have a total of 16 small tools displayed (excluding the page
number and the page-position tool) … if the two tools are missing (and
the bottom two tools are mirror and distortion tools), then something has
gone very wrong!
These two tools are the same as those in PDraw 2.0
Mike (from the UK)