PVR & Premiere
4 messages in this thread
Anyone had any luck with Premiere and the PVR? I got the 4.0a update, but when
I try to "make movie" I get an "Internal error"from Premiere. I have followed
the directions in the manual for setup, but have not had luck. The files load
properly and can be previewed in either Premiere on on the monitor. All seems
fine until I try and output back to the Perception. It will MAKE an Indeo 3.2
file properly.
I am not sure about the "cfcodec.avi" file. does this need to exist, if so how
is it to be created? It seems by the documentation that this file is created by
the CODEC and is some sort of swap file.
Tom
Thomas,
Although I am not an expert on Premier, it sounds like for some reason Premier
isn't able to talk properly to your Perception card when it wants to write. It
could be alot of things causing this. Sometimes the mirror directory gets
messed up, and so files can't be "Dummied" properly or else I think your
problem may be in the CODEC CONFIGURE: "advanced settings" in your Perception
Software. Check the Perception manual again to see if your advanced setting
match those that are recommended.
These are just a couple of guesses since I don't use Premier, but I hope they
help you.
Take Care.
Eron
Thanks Eron,
I did finally get it to work, It seems that the Premiere interface is very
particular in is file location requirement. I got everything working by making
sure all specified files were in the DPS_PVR mirror directory. I was wanting to
use my second drive instead of the primary drive. ( Iuse my primary drive for
programs only since it's only a 1 gig drive. My secondary drive is 1.6 gigs and
is used for all my network images.
Thanks for your help, it sent me in the right direction.
Tom
Glad I could help you Thomas.
Good luck!
eron
in:sync technical support