#PPak Local access prob.
3 messages in this thread
I'm trying to enter some new announce messages in myPPak system to
no avail I have been able to do this in the past with few problems,
however I'm now unable to access my system in local mode from my
telephone. I lift my phone, go into local mode, and then press # 0
(nothing happens) my phone is active as evidenced by blowing in the
mouthpiece. The only thing that is different from when I origionally
installed it is that I have upgraded to 2.4. I have run through all
procedures ppgs. 30-33 in my manual. I'm running an Amiga 3000/17.
with 2 meg of chip. Total memory of 7863264.
Hi Bruce
Try pressing # 0 without going into local mode. Local mode is only used
when you want to record new messages. # 0 if you want to test your setup
as if you were calling from another phone.
Hope this helps.
-Gary
Gary Giles
Yap Yap all the way from the UK Via Autopilot
Bruce,
It is very important when updating to version 2.4 that nothing of the original
software still exist. In most cases, users will place the LINEMAN program in
their WBSTARTUP drawer for automatic activation. This will cause a problem
when updating to version 2.4, since it will be looking in the PPAK drawer for
the previous version. If other files have been moved, the update will be even
less successfull. The version numbers should have been updated on all PPAK
files. Check the versions you are running of LINEMAN and PHONEPAK. Try
re-installing from scratch onto another section of the hard drive (after
removing the PPAK and SYSMSG assignments). One of these suggestions should get
you up and running.
GVP TECH