#Drive LEDs
3 messages in this thread
I've an A3000/25 to which I recently added a C= 2010 internal floppy
drive. The jumper on the mother board was changed to accommodate the drive
as DF1:. There is also an external drive which has always been DF2:.
Everything works well, except that when either DF0: or DF1: is in use, the
other drive LED comes on and stays on solid as long as there is floppy
disk activity. No biggy, but enquiring minds need to know.
Advice, please. Thanks in advance.
Dickoux
Dick,
That light is like a bus activity indicator. When any of the disk units are
active, they will come on..
//
Gary Vander Mei on Auto-Pilot \X/
Gary,
GVM> When any of the disk units are active, they will come on..
Thanks for the info. Guess I should have mentioned that the DF2: LED only
comes on when that particular drive is active and DF2: being active does
not cause the other drive LEDs to come on.
Since DF2: is an external drive (and as such is plugged into the floppy
access at the back of the machine) it may not be on the same bus, huh?
Well, anyway, no biggie. Thanks again. Later. Dickoux