Connect Problem
3 messages in this thread
Hello. I'm having a new problem when I connect with Compuserve.
I have the SupraFAX Modem 9600bps. I have been linking to CIS with LAPM and
from 300 to 9600 bps without any problems. Even flow control worked.
I haven't changed my software and as far as I can see I still use the
factory defaults, so I don't know where my problem began.
The software loads normally. The program functions right up until I connect.
I get the CIS prompt and the host doesn't seem to receive any future input. I
also tried the demo version of AutoPilot, but when I get to the CIS prompt,
again CIS doesn't seem to receive my transmission strings.
If I do a "at\n1" however, I can connect to CIS but without data
compression, or error checking.
Does anyone have any idea's what may have caused this? Thank you in advance.
Regards, Henry
I seem to have the same problem. I have a Supra Fax modem and CIS immediately
hangs up on me when I connect unless I first issue a AT\N command to disable
data compression. It is not a software problem since I have used a multitude of
different programs with the same result. Without data compression I get a bunch
of garbage when I disconnect.
I would consider using Autopilot but since I cannot issue manual commands
before I dial I cannot even connect using that program.
Gregory,
you can issue "manual commands" of a sort. Select "Setup" from the
main screen, then tailor the modem commands required to make your
installation work to your hearts content. If your modem requires AT\N,
then put that in the "Modem Initialization" gadget.
I hope this helps.
Brian
bjbart@watnxt01.ucr.edu