I just purchased a used IDEK MF-5017 and it came with NO manual. Does
anyone know what the scan rate is?
I have the Picasso II board and have tried to figure out what to put in
the driver for the scan. The default is 38khz.
I also noticed that when I set the screen size to 1024 x 768 by using one
of the Picasso screen modes, the screen kind of messes up when I pull down
the WorkBench screen to see the screen underneath. I know at 38khz the
screen will come up interlaced but that should only cause flicker not the
screen problems.
Any ideas??
Thanks,
Norm M.
From Connecticut
>>>>On AUTOPILOT…..
MF-5017 scan rates:
Hor 15.5KHz – 40.0KHz
Ver 50.0Hz – 90.0Hz
Hope this helps.
DJ
On AP from Queens, the thrill and excitement of the Big Apple
Where a little paranoia is always a healthy attitude …