CompuServe test bed

CompuServe Thread

Autodesk Multimedia Forum · Autodesk 3D Studio

#Animation Master

3 messages in this thread
#130397From: MICHAEL CORTESEOct 21, 1994 11:08 AM
Hi Sanford, I saw your RoadRunner on the '3D Artist' cover and was wondering how you got the mesh so smooth. I did some stuff in Animation Master and DXFed it to 3D Studio where it always comes out choppy. Any Suggestions? How did you get yours so smooth? Thanks, Mike C.
#130465From: Brandon MacDougallOct 21, 1994 3:43 PM
I am stepping in here… but you can use autosmooth [object or elements] with a setting higher than 30 this shoud work just fine.
#130512From: sanford kennedyOct 21, 1994 7:08 PM
<smoothing from Animation Master> The DXF's don't need smoothing in my experience. You could set up the splines in Anim. Master to be rounded (be sure you havn't selected "peaked") and adjust the bias on the curves. It always works for me. Good luck. Sanford