AniPro & Log. Mouse
4 messages in this thread
Have been using this Logitech Mouse with AniPro 1.3 since I purchased
the program. Mouse Driver is dated 10/92 and is an update since my
original driver. I have become an expert at hitting the EC31 to keep
the mouse drive installed. I re-installed the program thinking that
maybe it needed to catch the difference in the driver..still no go on
keeping it installed. It works for a while and then dies. This mouse
and driver work great in all my other programs that use a mouse,
Windows and Dos. Any help in keeping the mouse working in AniPro will
be appreciated. Logitech Mouse Test says all is fine, yet with this
program it is a constant EC31. Computer 486DX2/66, 8 meg ram, Local
Bus, 25 Meg free on HD, AniPro reports 4 megs free after loading a 50
frame flc. Dos 6.2 NO DOUBLESPACE. Single speed Philips CD with
drivers loaded high. Base memory 580K. Mouse driver not loaded high.
If more information needed..Will supply.
Thanks……………………..Jane
It sounds like you are getting a memory conflict when you run AAPRO.
To see if this is the case: REM all the lines in your CONFIG.SYS and
AUTOEXEC.BAT except FILES, BUFFERS, PROMPT, and mouse. Doan't load a
video driver or anything. Run AAPRO and see if you still get the
problem. Most likely you won't.
Then just put lines back in one at a time until you identify what is
conflicting with the Mouse when AAPRO is running.
Thanks Brian, Will try and report back. Strange that I have not had
this problem before. It appears with AniPlay and AniConv too. Guess I
should also check and see if Logitech has any new drivers..or
Autodesk has any. I admit my mouse is old stuff but it has served me
well over the years and IMHO still the best mouse in the house. 🙂
"Guess I should also check and see if Logitech has any new
drivers..or Autodesk has any" None from Autodesk…