#HELP!! 2.04&9600baud
3 messages in this thread
HELP!!! Now that I got your attention, I need help with a problem.
I updated to 2.04, now I can not get my modem/computer to work at 2400+
baud. With 2.03 I was able to set my port at 38400 for CIS (using Whap),
the same for NCOMM for local BBSs. I let the modem set the connect rate
and had the port locked at 38400. Now if I go above 2400 I can normally
connect ok but after a bit I get a 'NO CARRIER' message. I have tried
9600, 19200, 38400, baud settings and setting the buffers from min to
maxium. Any ideas, fixs, comments, or HELP???
Oh, here is the system setup. A3000/25, 2megs chip, 4megs 32bit fast,
8megs 16bit fast (Supra card, this was added at the same time as the
upgrade but I do'nt think this is the problem), 50meg HD for SYS:, 211meg
HD for the rest, Incomm Turbo 96/V.32 modem.
The system worked fine before the upgrade, and works fine now at 2400 baud.
Other that this problem with the speed it works great now. When I get time
I was going to re=-intsall 2.03 and see if it corrects itself. But for now
does anyone have a Idea what is wrong.
Michael Davis //
\X/ AMIGA POWER
Michael,
I've not heard of a problem like yours before, so I don't have any…
"solid" ideas, but I would recommend pulling the 16-bit memory board
from… your system and see if that clears up the problem. If so, I'd say
that… the problem lies either with the Supra memory board itself, or with
the… fact that 16-bit memory on the 3000 bus is very slow (relatively).
You'd… be much better off adding the memory to the 3000's motherboard
(which can… hold up to 18 megs total).
Hope this helps….
…BobR
Hi Bob,
I will try that. I already have 4 megs of fast ram on the MB, but I had
this 8 meg board sitting around, maybe I just put it back into the 2000.
Michael Davis //
\X/ AMIGA POWER