#I Love OS/2 & 3DS!!!
8 messages in this thread
To anyone who is tired of doing a test renderings and then shutting down to
remove the large Phar-Lap swap file. Move to WARP! OS/2 provides as much
virtual RAM as 3DS needs. 3DS therefore never creates a swapfile! OS/2's swap
file size is dynamic(based upon the need of 3DS). I can't tell you how happy
this made me to discover. You can also send TGA's to your PAR in the back
ground while your say posting email on Compu-Serve!
Scott Lunsford
Hi Scott..
I just put warp on my machine what program settings are ya using?
Thanks in advance……..Harry Dusenberg
Harry,
Download the file 3DSOS2.ZIP in the 3DS download section. It contains all the
settings you will need.
Scott
Scott,
I purchased Warp recently. I have a Diamond Viper w/P9000 chip 2meg version.
Though Warp runs fine, as do all my Windoze apps, 3DS will not run. The Vibrant
drivers return an error saying it can't make a BIOS call to my board!? Is there
anything you know of that I can do to fix this? If I can't run 3DS, Warp does
me no good.
Thanks
Jack
Thanks Scott … Will do.. Warpin out Harry D…
Scott,
Just got my copy of OS/2! Have been reluctant to install it since I was in the
midst of end-of-the-quarter rush at school (OH ST U). Any suggestions about
the best way to set up for optimum use of 3DS?
Jodi
Scott,
Could you post the details of your WARP setup? I've installed it but I find
that it accesses the disk when rendering a project that doesn't swap on my
idendical DOS machine. I have 32M, so memory should be no problem. I'm almost
at the verge of reinstalling DOS…
Many thanks for any help,
Paul Simpson – Hyperbolic –
Go into the DOS settings, set DPMI to enabled, and the DPMI memory limit to 64
meg or so. It sounds like your DPMI memory limit is too low.
LAM