I have a PP&S 040 board. I just installed 4 more megs of ram which brings
me to a total of 8 megs of 32bit and 6 megs of 16 bit on an 8up! board.
With only 4 megs of 32bit ram, 2 megs had to be configured to the 68000
range, but now with the additional 4 megs I don't know if this is
necessary. My comnputer seems to be running the same as before (except for
more ram of course) but I was wondering if anyone knew if I could put all
my 32bit memory into the higher range. The manual is unclear about this so
any help would be appreciated.
The Worst That Is..
Is Better than the Best that Could Be.