#CG Book
2 messages in this thread
Jerry,
Is it possible to take a file that is typed into the CG and put it on a floppy
disk?
I had created a lengthy file on my PC wordprocessor. Loaded it into CG. Then
made a number of changes to make it fit and about half way through decided that
I could finish the changes faster on the PC. But, I could not figure out any
way of going from the CG to disk.
I went into the directory that holds the projects and found the BK file. But,
when I loaded that into my PC, all it held was the font information. Were are
all those CG pages stored?
Also, speaking of projects. How do you know which project you are in when the
Toaster first loads? I noticed that is seems to load the last project I'm in
when I shut it down.
I noticed that I can load one project, but in CG if I go to save a Book, it
saves under a different project name.
In two weeks I may not have to worry about these things. Hopefully the Flyer
will have made improvements on this, but in the meantime, I am just trying to
come up with some solutions.
Fred
Fred,
That's a good question about how to get the text from a Toaster CG page. I
can't answer it, 'cause I can't find 'em either, but it is a heck of a good
question, and one that I hope someone jumps in and answers!
Toaster does load the project that was loaded when you last shut it down. You
can get the name of that project by going to the SETUP screen and looking at
the bottom of the middle screen area.
Jerry