68020
4 messages in this thread
I left this in AmUser but thought I'd try here too. I just installed the
DKB multistart and a GVP scsi controller in my 2000 which has the CBM 68020
bd. don't remember the number. Anyway before installing the DKB, etc. I had
no problem switching the 20 bd. to 68000 mode as needed now, however it
won't switch, it will only boot in 20 mode. Any ideas, I put the newest
ROM's on the bd. to work w/2.04 and have no probs. in 20 mode. but I can't
get the sucker to trap the mouse buttons to go to the 68000 mode. Any help
appreciated. I don't know whether the prob is in the GVP autoboot or the
DKB bd
Don,
Is it possible that the DKB board uses the same mouse buttons to
control the rom boot? If so perhaps it's trapping the button and it never
gets to the 2620 board. Just a thought.
Steven:
the DKB Multistart board doesn't use the mouse buttons, to change ROMs you
have to hold down the Ctrl-Amiga-Amiga key combo down more than 5 seconds,
then when you release them you'll boot into the other ROM.
-Mike Schiller
In sunny Fort Lauderdale
Mike,
Nevermind!