#Imagine Render Problem
5 messages in this thread
Hello from Tokyo. I'm having trouble with Imagine. When I try to render the
image after having generated it, the image shows O.K. but CLICK doesn't
make it go away. I can't go back to Project editor screen. So everytime I
render I have to reset the machine. I'm using A2000 with GVP3050
accelerator and Quantum 105MB HD with Trumpcard A2000 Professinal card. The
trouble has been happening even before I installed the hard disk card. Is
this incompatibility problem? or am I doing something wrong? Any help would
be appreciated. — Yasushi
This is a common problem with using Imagine. The secret is dont click on
the image while it is being shown, as this activates it and Imagine wont
cancel it. It you dont click on the image you can hit ESC to get back to
the project screen.
If you do click; move the mouse to the top of the screen, press the right
mouse button, and drag the image down. You should see the Imagine project
editor screen underneath. Click on its title bar to activate it, then hit
ESC.
Phil and Peter,
Thank you for your information. This ESC key method and draging menu
method both worked fine. I wonder why Impulse didn't include such an
important thing in the manual (or did they?).
— Yasushi
Glad to help and I found out about the ESC key via Imagine Compendium
try pulling down the pic screen from the extreme top left then hit ESC or
if ya haven't hit the mouse button already just hit ESC and you'll escape