ACCESS!130????
3 messages in this thread
Keith
I have a problem with the new Access! 1.30. When I tried to do a down load
on a local board with Xmodem, it immediately times out then aborts. I have
used access! 1.29 with no problems on this same local board. I've checked how
my defaults are setup and all seems fine. (Note I did a download from
Compuserve with QB and had no problems with access 1.30)
Question on scripting. I access compuserve thur is own network, so I wrote
a script to respond to it's logon messages. Why does
\VD50\VW200\D4\w\m1\P"id"\m2\P"password"\m3\B causes Compuserve not to
recognize my password when the script ends just after sending the password?
But when I changed the ending by adding \P"choice"\m4 in between \m3 and \B
it recognizes it. So want I was trying to do is get thur the ID and PASSWORD
prompts then stop the script. What I ended up doing was extending the script
to repsond to Compuserve next Prompt ENTER CHOICE and she works.
Hayward,
Yes, there _is_ a problem (in version 1.30) with Xmodem downloads, PLEASE
(anyone reading this) do _not_ re-post version 1.30. I will post a fixed
version in a day or so (if you have already, please pass the word around that
there is a problem with Xmodem (and possibly Wxmodem) but CIS-B protocol
works fine).
re: scripting…. my guess (from what I can gather from your listing) is
that there is not a <return> type char at the end of your F3 (password
macro). There needs to be one there, check that and see if that's the case.
Keith
Keith
I checked and there is a return key (\r). I wait for the new version and try
again.
Hayward