This is an archive of CompuServe forum messages from 1985 to 1995, as saved in transcripts by John Foust.
Search Results (11 messages)
screen rez & 2.0
Message #90624
I still have 3ds version 2 and I just upgraded my SVGA card from 256k to a 1 MEG with Windows accelerator. Now I am wondering, how can I increase the resolution of the display when I render to the screen? Thanks Shawn
3DS 1.0 disks
Message #51428
You know, I just realized that I no longer have my disk 1 from 3d studio 1.0 because I had to send it in to receive 2.0. I now have two computers and I want to run 1.0 on one of them since 2.0 has the hardware protection key. Since…
Well since there isn't a one to one correspondence with the say it is reacting ( at least in this case), I was hoping I could modify the path of the camera. I found that this wasn't true and I have altered the dummy's path and that helped a lot,…
Yes I am aware of the Path thingy – the problem arises from the fact that the Camera is a linked object to a dummy that is following the path. Also the camera has been adjusted so that the point of view also follows the path. What I had happen…
#keyframer/path/follow
Message #17131
Ok, here is my question. You are in the keyframer, you import a path for the camera to follow, you make a dummy object and assign it to the path. Now you link the camera target and the camera to the dummy. Now you set up 'Follow' so that the…
Well I found that if I have everything connected and then turn the printer on and then turn on the computer, the dongle works, haven't tested printing yet (i just did it this second). Thanks for the info.
Well I did contact my dealer, it seems that the lock works as long as the printer isn't hooked up to it. I have an Epson LQ/570 and I am using a high quality cable. Do you have any answers?
It says on page 8 of the installation guide under 'Cautions' to not turn on or off a peripheral device will the hardward lock is connected, it may cause hardware lock failure. That is where I got the information from.
#Dongle Problem
Message #12561
Ok, I just got my long awaited for upgrade to 3ds r2 and I already hate the dongle. First off I have only 2 25 pin ports, I am assuming the printer is the parrallel one so I hooked up the dongle to it. First 3ds doesn't see it and…
#10565-
Local 3DS Techeads?
Message #10657
Great, I will get a hold of you this week sometime – I would love to talk to other people that have this lovely little program.
#3ds Keyframer
Message #762
I am trying to find a way in 3ds to have multiple objects and bring them in and out at different frames, hiding the object doesn't seem to work, anyone have an opinion? also I am looking for a way to move an object from frame to frame and not…