#upgrade
I recently did a major upgrade on my A3000 and have run into trouble.
I upgraded to 3.1, Buster 11, new WD controller chip, added a high density
floppy, and added another 4 meg of ram.
When I went to boot the beast I was greeted with a blank, black screen. The
hard drive is a Fujitsu 330 meg. When I replaced that with an old Quantum 105
the system started up just fine and I was able to install the 3.1 software and
everything is working fine.
I sent the drive to Fujitsu and they assure me that the drive is in working
order. They did replace the motor with a faster one but I still get a blank
screen.
Any ideas?
One more thing. My screen still shows the RAD drive I had set up but on a warm
boot all I get is a CLI screen with a cursor. That screen doesn't understand
any commands.
I'd appreciate any help.
Paul Satterthwait