CompuServe Messages

>> I think I almost have my DC1tv problems all solved. I'm close too. My problem had been my Adaptec controller card. Unlike you, I have an ISA bus Adaptec 1540CF with ROM at CC00. This conflicts with the default address for the RAM on the DC1 TV. I moved the Miro DC1 TV RAM to D000 and now I can do captures. I haven't tuned anything for speed yet, and the captures drop a few frames every 4 minutes or so. Moreover, I had to reconfigure my Ensoniq soundscape sound card and now I will have to spend time getting the MIDI to work again. Sigh. > the exclusion must appear in both files Yep. I added "X=D000-D3FF" to the end of the EMM386.EXE line in Config.sys and also added "EMMExclude=D000-D3FF" to the [386Enh] section of SYSTEM.INI. > an ATI MACH64 and an Adaptec2940W. Today I ordered an Adaptec 2940 (for PCI bus) to get both the speed increase and the simplification of ROM, I/O, IRQs, etc. They didn't have the much faster wide Adaptec 2940W at Gateway and I don't have wide hard disks, but I suspect I should have insisted on wide anyway. I'm one breakthru closer with no help from any vendor. I still swear I will buy the first PCI bus video capture card that comes along. Without hesitation. > System.ini [MACX] section, add "Bitmap=off" & "Bitmaps=off" I haven't tried that. What problem did that fix? Jim Gast