#24 bit animation
Has anybody out there seen a side by side comparison of a finished project
(animation) done in DCTV as compared to Toaster with a single frame
controller and related hardware?
I realize that there is a huge difference, but I would like to see it
quantified somehow. For example "if Lightwave is the master tape then DCTV
would compare as a fourth generation dupe".
I have a Toaster but no frame controller or BRS 811 type VTR. Without
the top end hardware is Lightwave to ADPro to DCTV the only choice? Is
there something in between that might work for getting close to real 24
bit. If there was a cheaper method for roughing out the work I could then
rent the equipment to lay down 500 or so frames to tape when I have the
rendered frames all ready to go.
Any thoughts or comments?
Paul
–pt–not seattle– 😉