Turbo Silver
This message turned up in search, but its forum couldn’t be identified from the original transcript, so it may not be linked into its thread.
As this is just a temp PPN I'm currently using, (another day or so) won't
be able to re-respond if these suggestions don't work. Our permanent setup
for CIS should be up and running in another week or so, so please don't
keep this PPN as permanent.
As far as mapping goes, it sound like ou may have an axis that is too small
in size. Mapping isn't all that difficult, but it does take some practice
to get the "feel" of whats hapening. Try the following as a simple test.
First add a sphere of 50 units in size to the editor surface. Nest, add an
axis to the editor surface, and re-size it to Z = 200 , and X = 320. The Y
axis is of no concern. position the Axis at the lower left of the sphere.
select the axis (it turns blue) and under the attributes menu select Color
= IFF Brush.
Under the brush menu, load a 320X200 IFF pic in to the first "unsued"
space. Next group the Axis to the sphere by using multi-mode (left shift
key) Select the Axis first then the sphere. When both are blue, hit right
amiga "G". When the re-draw is complete, hit right Amiga "K" to cluster or
pass the IFF attriubutes to the sphere. That should do it. The othere
things to keep in mind are, that you probably want to turn blending on the
IFF brush down to 0, and remember that the right and left sides of the wrap
meet at the Z axis.
The final manual is being finished outside of our facility, and should be
done within 30 days. You may want to give our office a call, and ask for
the 1.1 doc. The ctrl/shift asterik is a signal. When in this mode, and
doing a rotation, all object picked will rotate or scale on their own
independant local axis at the same time and rate.