CompuServe Messages

Hello all, I just recievedmy new WARP ENGINE 040 and after some time in dry dock our 4000 is now back together again. My problem is I just installed a new Quantum Prodrive 540LPS. The WARP ENGINE SCSI Toolbox recognizes the drive but doesn't report back the correct amount of blocks or cylinders. The result is the 540MB ending up a -94MB drive (fancy that). I did not get any specs with the drive so I am dead there. I did try the WARP's SCSI Setup which just locks the system up when you select initialize disk. The Amiga 3.0 Harddrive toolbox is worthless because it doesn't even recognize the harddrive as being there. I have check ID's but thats OK. My current configuration is as follows : 120 IDE Drive 540 SCSI Drive (at ID #6) 3401B SCSI CD-ROM (at ID #5) Warp Engine SCSI Controller at ID #7 Any ideas, comments, suggestions are welcome. If anyone also has the specs for the drive above they would be appreciated too. Thanks Shawn Silent Paw Productions Still in the shipyard awaiting true Warp Power ("Cap'tn I'm working as fast as I c'an)