Amiga 4000 Pwr.Supply?
04-Jul-94 14:23:33
Sb: #155161-Amiga 4000 Pwr.Supply?
Fm: Shawn Randolph 71161,1565
To: Hilary Szymanowski 70035,510
Hello Hillary,
I don't know if this will help but I had a problem before with
the Toaster / TBC III combo. When trying to install the software
the system would fail when it reached any point when it looked
for the card (I believe around 30 or so it did this check, but
its been a while). The problem here was that the TBC card was
connected to the internal communications connector on the
motherboard. When the toaster started up it had a real problem
with this. When I switched to the external connector it was happy.
The toaster is very sensitive to your configuration so I will
tell to do the things that I always tell my customers. Start
with the basics and then add things in until the machine fails.
At that point hopefully you have found the culpret.
If you have 4000 with extra goodies in it first remove those items
and them with only the Toaster installed try to reinstall your
software. Make certain you disable all small utilities that you
might be running at startup.
Please also check the unreasonable like make certain that the
toaster card is configured correctly. IE that its daughterboard
is seated in the 4000 position and that all your jumpers on
the toasters main board are set to 4000 (Sorry can't remember if
that's down or up. It does say though in the manual and on the
board).
I have a 4000 with a 2x CD-ROM, 510MB Quantum, 120MB IDE, a
WARP Engine 040/40 with 20MB or RAM on it with a stock Power
Supply so I would say that while its possible that may be your
power, it is more likely something else (but CBM did make junky
power supplys :), I think they are made in French Polynesia or
the Belgium Congo (just kidding)).
If you have a stock 4000 also try the above with no other
programs loaded. I do not know if you are using the stock 120MB
harddrive or not but if you are using an older drive in addition
to the Amigas stock 120MB, like an older Seagate then that may
be your problem as well (ie: SCSI Termination or the increased
power demands from an older drive).
Sorry for meandering, hope my babbling helps…..
Shawn
Silent Paw Productions