#Syquist Instal Problem
15-Jan-94 20:52:50
Sb: #76208-#Syquist Instal Problem
Fm: Jim Hawkins 76520,3356
To: Gus Grubba 70673,1605
Thankyou all for your responses. I see that more information is necessary.
The problem I have is that when I go into my PC setup there is only room for 2
HDs.
So, it doesn't look like I can configure it in without removing one of the
other drives
which I don't want to. The drive comes with an IDE controller card and a
driver
which get has to be copied in and added as a device in the config.sys. I did
all that and the processor just hangs when I try to boot up.
I called up a local PC shop and they said they could do it but it would be a
big deal.
I am willing to do that, except right now, I cannot afford to have my PC in a
repair shop because I have to do some animation work with some tight deadlines.
Soooo,
if I can figure out how to do it without turning it over to the repair shop,
I'm all set.
The documentation said something about having to reconfigure other IDE devices.
I don't know enough about it to know exactly what that means. My otther two
drives ARE IDE drives.
Jim Hawkins