#How2 Install 2.04ROM
I am installing a new 2.04 version of workbench(kickstart) in my old A500
(rev.5.0)with 1meg fatter Agnus and 2meg added memory on a BaseBoard). I want
to keep the old 1.3 ROM usable so I am using a Switch-IT device so that I can
use both old and new workbench systems. The direction from CBM says to
"jumpered" pin 1 (A17) on the 2.04 ROM to pin 31 (A17) from the PCB. I am not
familar with the use of "jumpered". Does that mean to run a jumper wire from
pin 1 on the chip to pin 31 ? Should these pins be soldered ? Or does it mean
to connect a link from pin 1 on the chip to pin(socket)31 on the ROM socket?
Should any pins be cut off ? The first directions that I have indicated come as
is direct for the CBM instruction sheet. Can anyone help with this project.
Thanks.