#TERM Help Needed
30-Oct-93 13:22:49
Sb: #120173-#TERM Help Needed
Fm: Adrian Neal 100101,3667
To: Rob Stanton 74075,116
Rob,
Having just completed a quick sesson with Term 3.1 with the settings below
I know they work with that version and I would think they work with 3.4 as
well. Anyway give a go.
Serial preferences were as recommended by CompuServe ie 9600 baud,
"7-1-E".
Within Term use the "Settings" menu and "Serial" option, it should be near
the top.
Baud Rate : 9600 Strip bit 8: (tick)
Bits/char : eight High Speed mode: (tick) note I think this is
the actual trick
Parity : none check carrier: (cross)
Stop bits : one shared access: (cross)
Handshaking: RTS/CTS(DSR) xON/xOFF: (cross)
Duplex : full
I hope that they work for you. Good luck
Adrian