#3DS R3 Help Me!!!!!
We have a problem with the configuration on 3D Studio Release 3. We are running
on two 486/50 Mhz with 32Mb of RAM. We have tried running on DrDOS 6.0 and we
are presently running on MSDos 6.02. The system is networked with Novell lite.
When we load 3D Studio from DOS the program takes an eternity to access. Once
we are in the programme it takes forever to change from any of the modules to
the materials editor. We are also unable to run Autodesk Aniplay from DOS Shell
without it seeming to page the disk. We have tried taking everything out of the
Config.sys and the autoexec.bat. Since we have changed to MSDos 6.02 (and
configured the memory using `Memmaker') we are getting an error when we try to
access Autodesk Animator Play of the following:
"Phar lap err 35: the 386 chip is curently executing in virtual 80/86 mode
under the control of another program you must turn off this other programme in
order to use 386|DOS-extender to run in protected modes."
It seems we have a major memory allocation conflict somewhere but we are unable
to pinpoint the problem.
CAN ANYONE HELP??? WE ARE DESPERATE FOR A SOLUTION!!!! Alan [D [D [D [D/exit
\exit